| |
|
| |
MODEL: CPAAF
AUTOMATIC AUGER TYPE POWDER FILLING MACHINE |
| |
| |
|
| |
TECHNICAL SPECIFICATION |
| |
Model |
CPAAF-1 |
CPAAF-2 |
| Direction |
Left To Right. |
Left To Right. |
Production Rate
30 mm neck dia. With 0.6 bulk density. |
Fill range depending upon Bottle opening and bulk density of powder
30-40 PER min. |
Fill range depending upon Bottle opening and bulk density of powder
40-50 PER min. |
| Fill Capacity |
75 gram to 150gram (with different set of Auger and funnel) Fill range depending upon Bottle opening and bulk density of powder. |
75 gram to 150gram (with different set of Auger and funnel) Fill range depending upon Bottle opening and bulk density of powder. |
| Accuracy |
± 2-3% depending upon consistency and the Uniformity of bulk density of powder under controlled level of Humidity (i.e.35%) (Maintaining hopper feed level) |
± 2-3% depending upon consistency and the Uniformity of bulk density of powder under controlled level of Humidity (i.e.35%) (Maintaining hopper feed level) |
| No. of Heads |
Single |
Two |
| Electrical Supply |
1.00 HP For Main Drive.
0.50 HP for conveyor |
1.00 HP For Main Drive. Each
0.50 HP for conveyor |
| Power Requirement |
440 Volts, 3 Phase (4 wire System) 50 Hz. |
440 Volts, 3 Phase (4 wire System) 50 Hz. |
| Height of Conveyor |
Adjustable from 850 To 900 MM |
Adjustable from 850 To 900 MM |
| Bottle Diameter |
25 MM To 90 MM MAX. |
25 MM To 90 MM MAX. |
| Height |
55 MM To 210 MM. |
55 MM To 210 MM. |
|
| |
|
| |
NOTE: Semi automatic model of powder filling along with only filling unit with scrambler, unit with scrambler filling Stoppering un-scrambler, Monoblock and trio block type model of filling Stoppering and sealing or inspection, media filling arrangement for validation, and lab testing. Additional feature of weight testing, check weighing, facility also available. |
| |
| |
| OPERATION |
The incoming dry bottles containers is fed through the in feed Turn Table with suitably guided on the moving S. S. / delrin flat conveyor belt at the required speed for feeding. There are separate filling head mounted on machine top plate in the same line. When bottle reaches to the first filling station, it will be held by the mechanical/pneumatic bottle holder. Immediately it will be sensed by the bottle sensor as soon as it gets signals from sensor Clutch motor/Servo starts to rotate which is mounted on auger shaft. It will fill the desired amount of powder to the bottle through auger, where rotation time is previously saved in logical control unit / PLC control. After filling of first bottle Mechanical Wheel/ pneumatic piston goes back or rotates and release the first bottle to move on conveyor, by the same time second bottle also moves along with the first bottle in empty condition. In second filling head same operation will be performed but this time second bottle get filled and first bottle moves further for next operation.
|
| SILENT FEATURES |
- “NO BOTTLE, NO FILL” System eliminates wastage of costly powder.
- Mechanical / Pneumatic bottle holding system is connected with auger rotation, which eliminates chances of bottle transfer before completion of filling operation.
|
|
|
| |
|
|
|
|
